expresslat.blogg.se - 815 cisco router ios for gns3

815 cisco router ios for gns3 serial number#
815 cisco router ios for gns3 manual#
815 cisco router ios for gns3 Pc#

Supports interface card with four 10/100-BASE-TX Ethernet switchports.

815 cisco router ios for gns3 Pc#

This port autosenses the speed (10 Mbps or 100 Mbps) and duplex mode (full- or half-) of the device to which it is connected, and then operates at the same speed and in the same duplex mode.Ĭonnects to a modem for remote configuration using Cisco IOS software.Ĭonnects to a terminal or PC for local configuration using Cisco IOS software. Figure 1-5 shows a closer view of the HWIC-CABLE-D-2 module, which is installed in the WIC 1 slot on the router.Ĭonnects the router to the local Ethernet network. Figure 1-4 shows a closer view of the WIC-4ESW module, which is installed in the WIC 0 slot on the router. This section describes the router back panel ports and LEDs, which are shown and identified in Figure 1-3 and are described in Table 1-2 and Table 1-3.

815 cisco router ios for gns3 serial number#

(See Figure 1-2)įigure 1-2 Serial Number Location on the Cisco 815 Router The serial number label for the Cisco 815 integrated services router is located on the rear of the chassis, to the right of the power switch. Supports IP, IPX, AppleTalk, IBM, Open Shortest Path First (OSPF) Protocol, NetWare Link Services Protocol (NLSP), Resource Reservation Protocol (RSVP), encryption, network address translation, and the Cisco IOS Firewall Feature Set.ġThe HWIC-CABLE-D-2 operates only in WIC mode with 8-Mbps downstream throughput.

Router can be secured to a desktop or other surface using Kensington lockdown equipment. Router can be managed over a network using Simple Network Management Protocol (SNMP).Ĭonfiguration files can be easily downloaded to the router over a WAN connection. Supports modem connection to the router, which can be configured and managed from a remote location. Supports router configuration and management with a directly-connected terminal or PC. Note These slots are fixed and are not field replaceable. Supports a WIC-4ESW and HWIC-CABLE-D-2.

Supports IEEE 802.1Q VLAN encapsulation.

Supports autosensing for 10- or 100-Mbps operation.

815 cisco router ios for gns3 manual#

Operates in full- or half-duplex mode (with manual override available).

The Cisco cable modem high-speed WAN interface cards (HWICs) are installed in the router as a fixed configuration for one HWIC full-feature cable modem high-speed interaction, including quality of service (QoS) functionality.įigure 1-1 Cisco 815 Integrated Services Router The Cisco 815 integrated services router communicates over a cable hybrid fiber coaxial (HFC) network for office-to-Internet connectivity or branch-to-branch connectivity. The Cisco 815 integrated services router (see Figure 1-1) is a small, modular desktop router that provides an integrated cable solution.

This chapter introduces the Cisco 815 integrated services router, also referred to in this guide as the router, and covers the following topics: